Service & Maintenance Packages
SERVICE & MAINTENANCE PACKAGES
*Prices do not include service fee
WINTERIZATION: $200
Drain water lines and fresh water tank
Drain water heater and pull anode rod
Disconnect batteries for storage
Propane System disconnect
Antifreeze fill (up to 2 gallons of Antifreeze)
DE-WINTERIZATION (BASIC): $200
Re-install batteries
Top of battery fluid levels
Reconnect propane tanks
Flush waterlines of Antifreeze
Check for leaks in water system
Re-install anode rod/drain plug to water heater
DE-WINTERIZATION (EXTRA): $400
Includes De-winterization package, plus:
Operation test of refrigerator (LP + electric), water heater (LP + electric), furnace, air conditioner, stove
Clean and/or Replace air conditioner air filter
Safety equipment check + alarm battery replacement
Tire inspection
Air fill
LP system check
Electrical system check
AIR CONDITIONING SERVICE: $175
Inspection & cleaning of evaporator & condenser coil
Capacitor testing
Compressor testing + amp draw
Air filter replacement
Delta-T test
Price is for 1 unit (additional units $100 each)
FURNANCE SERVICE: $175
Clean main burner surface
Clean blower wheel
Clean and inspect combustion chamber
Clean, inspect and adjust electrode assembly
Inspect fan motor
Clean + inspect vent tubes + outer casing
LP drop test
Check complete operation
WATER HEATER SERVICE: $175
Check heating element
Anode rod inspection, replacement if needed
Thermo couple inspection
Relief valve inspection
Control board inspection
Clean and adjust burner assembly
Check operation on LP and electric
REFRIGERATOR SERVICE: $200
Inspect door seals
Inspect ventilation and baffle
Inspect air tight unit installation
Clean roof vent
Check voltage in control board
Clean and adjust burner assembly
Check heating elements
Check LP operation and AC operation
COMPLETE APPLIANCE SERVICE: $600
Furnace service
Water heater service
Refrigerator service
Air conditioning service (1 unit) $100 per additional unit
LP SYSTEM INSPECTION: $175
Check dates on LP tanks & regulators
LP pressure drop test x2 start of tests, end of tests
LP Operating pressure test
LP lockup test
Visual inspection of rubber hoses
ELECTRICAL INSPECTION: $200
Test voltage at all outlets
Test GFCI outlets
Inspect breaker at distribution panel
Inspect wire connections at distribution panel
Inspect/test converter
Pull and test 12VDC fuses in distribution panel
Check switch operations
WHEEL BEARINGS: $250 PER AXLE
Pull bearings
Reseal bearings
Discard old grease
Tighten lug nuts
Check and fill tire pressure
SAFETY EQUIPMENT INSPECTION: $200
Inspect all safety alert devices are up to date and properly powered (fire alarms, carbon monoxide alarm, propane leak alarm, LP regulators & tanks)
BATTERY SERVICE: $100
Clean terminals
Clean battery tray
Top off battery fluid
Coat terminals and connections with dielectric grease
Load test batteries (up to 2 batteries) $25 each additional battery
*Prices do not include service fee